Help with bricked w810i

[ts014]

use xs++3.1

[silversnak]

use xs++3.1

I did, and that's where the problems started. I was successful in changing the main from R4GC010 to R4EA031 generic with SETOOL2 lite and even had a couple of mods installed. However, the FS was giving me a config error anytime I tried opening up the menu. I tried flashing the FS with XS++3.1 and I got a flashing failed about halfway through (this is where the problem started).

Now most of the time in XS++ I get a "Sending db2010_cid00_prodid_p3l.bin..." and it hangs, or a "Sorry, your phone is NOT SUPPORTED / Sendinging shutdown signal to phone... / Shutting down..." message when I do try to flash the firmware, and SETOOL2 when it isn't giving me the dumps above and payload failed messages doesn't seem to ever flash the firmware this time even though it thinks it has.

So in all, I'm totally lost after trying to work with both of these tools for hours to get something going. Hopefully someone here has more experience and can help find a fix.