"Error: Phone not power up" Please help, tried everything.

[onlyone]

i'll tell you what to do. the other told you creppy thing, nothing you can use.
so find the picture below, it's self explainatory:
you must unsold the red wire (5V) form the side of the cable that goes into the phone.
if your cable is a service cable already, you will notice that pin 6 and 7 are in use for rx/tx transmision. but if your cable is using pin 4 and 5 then you need to unslod 4 and move to 6 and also unslod 5 and move to 7. then shortcut pin 9 and 11 also, cut the red wire. the wire at pin 10 must stay in place.




now my friend you can use usbsmart 3.3 to read all codes from your phone.
take care

usbsmart 3.3 can be found here:
RapidShare: 1-Click Webhosting

PS the red wire is charging your phone and you will be unable to unlock if you don't unsold it or cut it because your phone will start over and over again (i wrote this so you know why the red wire must be cutted off)