XS++ 3.1 Guide-Flashing, Customizing, Recovering

[riders4sia]

After performing a (K610_R1GB001_FS_EUROPE_5_RED51) flash using XS++
And a interruption from a power failure right at the worst time.
I read the Guideline from mohdumer...
It would seem that there is no recovery from a "bad" main/file system firmware flash

All I get is this response now...

08:08:21| XS++ v3.2 Dev1 (Crystal) Ready !08:08:21| Executed on Microsoft Windows XP08:08:55| 08:08:55| Attempting to open the interface...08:08:55| 08:08:55| TURN OFF PHONE!08:08:55| Hold 'C' button on phone and connect phone NOW.08:08:55| You have 30 seconds...08:08:55| 08:09:26| Error: Cannot open phone communication port08:09:28| Disconnected... Unplug the phone08:59:50| XS++ v3.2 Dev1 (Crystal) Ready !

08:59:50| Executed on Microsoft Windows XP
09:00:06| Attempting to open the interface...

09:00:06| TURN OFF PHONE!
09:00:06| Hold 'C' button on phone and connect phone NOW.
09:00:06| You have 30 seconds...

09:00:37| Error: Cannot open phone communication port
09:00:39| Disconnected... Unplug the phone
09:01:13| Shutting down...

In UR Opinion is there any hope or RIP?
Appreciated reply

try a fully charged battery and check if the usb flash driver is corrupt or not, try changing the usb port

Originally Posted by chandu3945 View Post
i wanna chage my phone to w800i can i do this

what phone do you have?