// MACROS
// ================================================== ================================================== =========
//

PIXEL_NOISE_REDUCTION =
#WRITE_SENSOR(34 C019)
#WRITE_SENSOR(40 1800)
#WRITE_SENSOR(76 7358)
#WRITE_SENSOR(04 0282)
#WRITE_SENSOR(03 01E2)
#WRITE_IFP(A0 0282)
#WRITE_IFP(A3 01E2)
#WRITE_IFP(A6 0282)
#WRITE_IFP(A9 01E2);
// Simple control register definitions
// -----------------------------------
CHIP_ID = $f FE 00 $f $sf 00; // Register 0x0000 in bank 0x00
CONTROL = $f FE 00 $f $sf 02; // Register 0x0002 in bank 0x00
STATUS = $f FE 00 $f $sf 04; // Register 0x0004 in bank 0x00
SIZE = $f FE 00 $f $sf 08; // Register 0x0008 in bank 0x00
FRAME_RATE = $f 1F4 00 $f $sf 12; // Register 0x0012 in bank 0x00

Esto lo obvie,sino era mucho el post..........................

// $f FE 02 $f B4 10 27; // Set Max exposure to 100ms or 10fps
////////
PIXEL_NOISE_REDUCTION =
#WRITE_SENSOR(34 C019)
#WRITE_SENSOR(40 1800)
#WRITE_SENSOR(76 7358)
#WRITE_SENSOR(04 0282)
#WRITE_SENSOR(03 01E2)
#WRITE_IFP(A0 0282)
#WRITE_IFP(A3 01E2)
#WRITE_IFP(A6 0282)
#WRITE_IFP(A9 01E2);
ROW_NOISE_REDUCTION =
#WRITE_CONTROL(3D 17DD)
#WRITE_SENSOR(5F 3630)
#WRITE_SENSOR(30 043E)
#WRITE_IFP(3B 043E)
#WRITE_CONTROL(2E 0000)
$d0064//delay 100 ms
#WRITE_CONTROL(2E 0C4A);
// Sensor configuration file
//================================================== =======================================
// Pulsar Patch File


Asi fue como quedaron los macros,pero no obtuve ningun resultado positivo,espero que haya sido porque los coloque mal... igual seguire probando,gracias jcmonx!