[RESUELTO] Que puedo hacer ayudenme problemas con w350

[jach88]

Le cambie el FW y quiza este cel venia parchado y con el cambio de firmware se lo quite.!!

No agarra ningun chip de aca de el Salvador.

Ha quedado con la leyenda:

Inserte sim correcta. Pero ya lo libere y sigue igual.

Que pasara.???

Saludos.

v0.915016/UNI
CARD SERIAL: 00*******
Loaded 51 flash descriptors
SIGNED MODE (USING SERVER).
ALTERNATIVE SECURITY BYPASS ENABLED.
ChipID000,EMP protocol:0301

PHONE STATE: "RETAIL"
FLASH CID: 0053
Speed:921600
OTP: LOCKED:1 CID:52 PAF:1 IMEI:35********CERT:RED
LDR:071213 1552 PERCXC1720441_R2A022_PNX5230_FLASHLOADER
Flash ID check:2019
Flash props sent ok
LDR:070904 1356 AN2CXC1250610_R3A016_PNX5230_CSLOADER
loader startup: executed
loader GDFS startup: executed
loader filesystem startup: executed
loader unlock: executed

DISCONNECT PHONE NOW
INSERT SIM CARD, FULLY TURN PHONE ON AND ATTACH AGAIN
INSTALL PHONE MODEM DRIVERS IF NEEDED

SEARCHING FOR PHONE, "STOP" TO ABORT
Can't find attached phone with IMEI 35*********
PROCEDURE WAS STOPPED BY USER
Elapsed: 145 secs.
SIGNED MODE (USING SERVER).
ALTERNATIVE SECURITY BYPASS ENABLED.
ChipID000,EMP protocol:0301

PHONE STATE: "RETAIL"
FLASH CID: 0053
Speed:921600
OTP: LOCKED:1 CID:52 PAF:1 IMEI:35********** CERT:RED
LDR:071213 1552 PERCXC1720441_R2A022_PNX5230_FLASHLOADER
Flash ID check:2019
Flash props sent ok
LDR:070904 1356 AN2CXC1250610_R3A016_PNX5230_CSLOADER
loader startup: executed
wrong response, break.
loader GDFS startup failed, that is fatal
PROCEDURE WAS STOPPED BY USER
Elapsed: 176 secs.
SIGNED MODE (USING SERVER).
ALTERNATIVE SECURITY BYPASS ENABLED.
ChipID000,EMP protocol:0301

PHONE STATE: "RETAIL"
FLASH CID: 0053
Speed:921600
OTP: LOCKED:1 CID:52 PAF:1 IMEI:35********** CERT:RED
LDR:071213 1552 PERCXC1720441_R2A022_PNX5230_FLASHLOADER
Flash ID check:2019
Flash props sent ok
LDR:070904 1356 AN2CXC1250610_R3A016_PNX5230_CSLOADER
loader startup: executed
loader GDFS startup: executed
loader filesystem startup: executed
loader unlock: executed

DISCONNECT PHONE NOW
INSERT SIM CARD, FULLY TURN PHONE ON AND ATTACH AGAIN
INSTALL PHONE MODEM DRIVERS IF NEEDED

SEARCHING FOR PHONE, "STOP" TO ABORT
PHONE FOUND AT COM22
PHONE READY TO PROCEED
CAN'T START EXECUTOR,RETRYING...
CAN'T START EXECUTOR,RETRYING...
CAN'T START EXECUTOR,RETRYING...

REMOVE CABLE FROM PHONE
REMOVE BATTERY FROM PHONE, THEN INSERT IT BACK
THEN PRESS "READY"
PROCEDURE WAS STOPPED BY USER
Elapsed: 197 secs.


Que pasó aquí.????

Será que no lo puedo flashear.???

O será que ya va para la basura.!!!


señores ya solucione el problema de mi w350a.!!!

Por cualquier cosa pueden preguntarme como lo hice...

Gracias ha todos los que me colaboraron.

Mil gracias.

Atte:JACH88