nafg
16/04/2008, 13:00:40
Cruiser Suite SE TestPoint Unlocker is an application for unlocking SonyEricsson phones. Currently supports only an Unlock-by-Patch, so the phone must be previously flashed with the desired firmware.
Currently supported platforms:
DB2012 - CID52 onlyCurrently supported phones:
Sony Ericsson W200
Sony Ericsson W300
Sony Ericsson W810
Installation
Run the installer file and follow the installation wizard’s instructions
Cable
Cruiser Suite SE TestPoint Unlocker requires a new Cruiser UC20 cable. The Cruiser UC20 cable consists of:
a data cable
power supply clips
a testpoint needle
Preparation
Make sure the phone has the desired firmware already, otherwise flash it with your favorite flashing tool.
Prepare the phone for the testpoint unlock.
- remove the phone cover
- make sure the Pin27 is clean and accessible
http://www.cruisersuite.com/data.aspx?file=articles/5e7ecadd0ca74831a2494e0afeb3e82f/makro_pin01_watermark3_web.jpg
Note: we recommend to use a binocular microscope for either preparation and testpoint connecting
Unlocking procedure
Make sure Cruiser+ Dongle is plugged in your computer. Card ID must end with “-07”.
Run SeTestPointUnlocker.exe
Choose the phone model.
Connect the data cable and power supply clips to the phone.
Double-click on the appropriate cruiser UC20 serial cable.
Wait until the program asks you to connect the testpoint.
http://www.cruisersuite.com/data.aspx?file=articles/5e7ecadd0ca74831a2494e0afeb3e82f/screenshot_testpoint_connect.gif
Connect the testpoint needle to Pin27.
When informed, the testpoint may be released, the program continues with unlock procedure.
Disconnect the cabling from the phone when program finishes.
Saludos
nafg
Currently supported platforms:
DB2012 - CID52 onlyCurrently supported phones:
Sony Ericsson W200
Sony Ericsson W300
Sony Ericsson W810
Installation
Run the installer file and follow the installation wizard’s instructions
Cable
Cruiser Suite SE TestPoint Unlocker requires a new Cruiser UC20 cable. The Cruiser UC20 cable consists of:
a data cable
power supply clips
a testpoint needle
Preparation
Make sure the phone has the desired firmware already, otherwise flash it with your favorite flashing tool.
Prepare the phone for the testpoint unlock.
- remove the phone cover
- make sure the Pin27 is clean and accessible
http://www.cruisersuite.com/data.aspx?file=articles/5e7ecadd0ca74831a2494e0afeb3e82f/makro_pin01_watermark3_web.jpg
Note: we recommend to use a binocular microscope for either preparation and testpoint connecting
Unlocking procedure
Make sure Cruiser+ Dongle is plugged in your computer. Card ID must end with “-07”.
Run SeTestPointUnlocker.exe
Choose the phone model.
Connect the data cable and power supply clips to the phone.
Double-click on the appropriate cruiser UC20 serial cable.
Wait until the program asks you to connect the testpoint.
http://www.cruisersuite.com/data.aspx?file=articles/5e7ecadd0ca74831a2494e0afeb3e82f/screenshot_testpoint_connect.gif
Connect the testpoint needle to Pin27.
When informed, the testpoint may be released, the program continues with unlock procedure.
Disconnect the cabling from the phone when program finishes.
Saludos
nafg