Flashing With Setool Lite 11

[rudie]

Thanks Jasmin, the phone will not connect to XS++ but I was able to connect it to Setool using this repair EROM guide I found online.

1. Start SeTool 2 lite
2. Press Unlock\Repair Button, The first button.
3. Reinsert Battery
4. Connect phone holding 2+5
5. Wait, SeTool 2 lite will repair the EROM, it will flash it back.
6. Done

This is the only way I can get me phone to connect. Here is the log, hope the phone is not complete dead. One thing the phone original software version is R7AC001.

Thanks again.



Welcome to SEtool2 ( LITE edition ) v 1.11
supported DB2010/DB2012 CID49/50/51/52, DB2020 CID49/51/52
Loaded 51 flash descriptors

if you like LITE edition - please visit Index of ./ and buy FULL.

ChipID:9900,EMP protocol:0301
BOOTROM MODE DETECTED
Speed:921600
OTP LOCKED:1 CID:51 PAF:1 IMEI:xxxxxxxxxxxxxx CERT:N/A
FLASH CID:52 COLOR:RED
LDR:061201 1314 HANCXC1329129_DB2020_FLASHLOADER_R2A005
Flash ID check:897E
Flash props sent ok
CSloader version:
070410 1557 HANCXC1250562_DB2020_CSLOADER_R3A009
loader startup: executed
loader GDFS startup: executed
smth wrong with usercode reset,error is: 1
Elapsed:77 secs.