How I unlock Sim lock from k610i

[Jorppeli]

Help me, i downloaded xs++ :confused:

[interferej]

read this http://www.topsony.com/forum/showthread.php?t=6329 if you don't understand everything... just ask

[mohdumer]

To Debrand Using XS++: XS++ 3.1 Guide-Flashing,Customizing,Recovering - Top Sony Forums
To Unlock: Remove SIM-lock patch generator - Top Sony Forums
Ever Thought About Searching Forums Before Posting:rolleyes:

[TheRascal]

Ever Thought About Searching Forums Before Posting:rolleyes:

I doubt about that. Every new member don't use the search button :). they just don't know even what is google. I think every new member 1st have to use the search button and then to write!!!

[Jorppeli]

not work :(

I can't get connect

21:04:52| TURN OFF PHONE!
21:04:52| Hold 'C' button on phone and connect phone NOW.
21:04:52| You have 30 seconds...
21:04:52|
21:05:25| Error: Cannot open phone communication port
21:05:27| Disconnected... Unplug the phone

[simox]

You need to install the USB Flash Driver: USB Flash Driver Installation - Guide

[Jorppeli]

You need to install the USB Flash Driver: USB Flash Driver Installation - Guide

i am installed it.

[simox]

And? It doesn't works?
When the program or tutorial says that press C button and connect the phone, you need to turn off the phone, remove the battery, wait a few seconds, put the battery back, but DO NOT turn on. Press and hold the C button on phone, connect the cable. When you see some progress in program(XS++, SETool2 Lite, etc.) release the C button.
By the way first press the button(e.g. the Connect button) in program, and AFTER that connect the phone.

[Jorppeli]

And? It doesn't works?
When the program or tutorial says that press C button and connect the phone, you need to turn off the phone, remove the battery, wait a few seconds, put the battery back, but DO NOT turn on. Press and hold the C button on phone, connect the cable. When you see some progress in program(XS++, SETool2 Lite, etc.) release the C button.
By the way first press the button(e.g. the Connect button) in program, and AFTER that connect the phone.

I do this:

1. Turn off phone (battery off..)
2. Connect XS++
3. But cable to computer and phone (put battery back)
4. Press "C"
-> not work :S :confused:

18:16:39| TURN OFF PHONE!
18:16:39| Hold 'C' button on phone and connect phone NOW.
18:16:39| You have 30 seconds...
18:16:39|
18:17:12| Error: Cannot open phone communication port
18:17:14| Disconnected... Unplug the phone

[simox]

I wrote already the correct steps in previous post. Why not follow that?
So, again:
1. press the "Connect" button in XS++
2. turn off the phone, remove the battery
3. wait about 5 seconds, and put back the battery
4. press and hold down the C key on phone
5. plug the cable in phone(WITHOUT releasing the C key)
6. when you see some progress in log window, release the C key