Question with flashin k750i@w800i

[b0mba]

hi!

in order to get flash lite wallpapers running on my k750i i´m going to upgrade the R1L002 firmware with gflash.

my k750 i is cid36 red

so can i use the w800 firmware from topsony site?

thx in advance ;)

b0mba

[paladinzluka]

Yes, you can flash R1L002 and you can see swf files

[b0mba]

Yes, you can flash R1L002 and you can see swf files

thx for fast reply ;)

i hope it will work fine coz its my first time flashing a mobile... hehehe

[HARUN15]

yes you can use it. but you must take a firmware for cid36

[avostrejz]

i hope it will work fine coz its my first time flashing a mobile... hehehe

You must do the "Full flash" - main FW, FS and even the customization. You can also use XS++ (PhoneXS). CID 36 is without problems :).

[Top Sony]

Latest firmware is R1DB001.
Flash only with that firmware.
Regards!

[phil397]

hi guys
i have prob with my k750i phone as in it started to say please wait when i swiched it on one day. was told it as crashed? so re flashed it with no change? tryed to reflash it to w800i useing
http://k750itow800i.blogspot.com/200...-to-w800i.html
but first when i tryed to flash fs file it said there was 291 blocks but only show'd 156 block's on XS & failed on Customizing FS :binary acknowledge failed with: 15? not sure if anyone really come on this site but if anyone can help i would be grateful. thanks

[sekal]

Hi Phil397,
I used the steps from the same site and my phone works fine.
Make sure you have downloaded the files properly.
If you have luck, retry may help.

[miroalex]

Latest firmware is R1DB001.
Flash only with that firmware.
Regards!

Yes it's the latest but R1BC002 is better because there are more patches and moddings available for that version.
for flash wallpaper in my opinion although flash wallpaers are good but R1L002 is one of the bugiest firmware! :D

[diezil]

@phil... which version of XS++ you using?
I converted my k750 CID49 to w800 today using XS++ v1.5 and i had sort of a similar problem but only the flash was going through but then it would freeze at "finishing flash", what i did was first flash the w800 Main firmware and when it gets to finishing flash i left it there for a few minutes to ensure it had completed the flash of Main, then i had 2 flash FS without customizing, and once again it froze at "finishing flash" so i left it for a few minutes to ensure it had finished flashing the FS and then hit close, then i had to start up XS again for a 3rd time to customize (this part went smooth), but all in all it done a great job on my 1 hour old phone hehe still has a total call time of "0"...

PS: Make sure your using the correct files, if its a CID49 you will need to run them through GSlide first which can be found here in the download section ;)
I also had to customize using the "own_custpack" when ever i chose the custpack for europe 2 thats built into XS++ windows xp spit out an error saying XS encountered an unexpected error and need to shut down, but custpack also found in the download section :)

If your phone is CID36 i surgest you use "GFlash" as its alot easier to flash a CID36 and can all be done in one stage ;) stick in your MAIN+FS choose your CDA and hit flash and 10 minutes later you'll have your converted phone, but GFlash is CID36 ONLY...