need v600 testpoint solution

[ts013]

No need to upload, like i said you get them instantly if you type k600 testpoint in google ;)

[marn]

if you write blank gdfs you format old gdfs.because may new value dont same by old value.so format old gdfs then write blank gdfs.

[nissenisse]

i want the picture i'm going to flash the erom any way becuse something is stil not right with the phone and it's good to have.

[ts013]

Didn't you read my previous posts?

[nissenisse]

Didn't you read my previous posts?

yes but the testpoint picture on the net dont for K600 and K608 does not look like the one on this v600
the image is from this phone and it does not have all tha parts like in k600 and k608.
look att the image with the word tp that area does not exist in this phone

[ts013]

There are two testpoints, try the other one:
Test Point de celulares - Top Sony

K600/K608 and V600 use the same hardware. I just looked at an old V600 I have here, it really seems like your board misses some pins.

[nissenisse]

There are two testpoints, try the other one:
Test Point de celulares - Top Sony

K600/K608 and V600 use the same hardware. I just looked at an old V600 I have here, it really seems like your board misses some pins.

i have tryed that testpoint to and that didnt work. it seems like it some differens betven swedish V600/K600/K608 and other countrys.
look here Dead K608 - SE-NSE Forums this is a swedish K608 and that to does not have that testpoint area.

[ts013]

Now thats really strange...

Anyway, if you got something like that:

PHONE IS INVISIBLE (00000000)
NO VALID FLASH CID DETECTED (00)

on SE Tool it's most likely that it's a problem with the hardware.

[nissenisse]

Now thats really strange...

Anyway, if you got something like that:

PHONE IS INVISIBLE (00000000)
NO VALID FLASH CID DETECTED (00)

on SE Tool it's most likely that it's a problem with the hardware.

this is what i get when trying to flash erom with setool but it works to flash main and fs with xs++ but not in setool

Loaded 49 flash descriptors
Open COM port OK
ChipID:7100,EMP protocol:0301
PHONE IS RED RETAIL PRODUCT
FLASH CID detected:49
Cowardly refusing to load empty loader.
failed to load CERTLOADERS,try to use RECOVERY.
Elapsed:1 secs.

[berthstein]

During TP, with semc tool -FLASH CID DETECTED- should be 29
I attach the tp I used for k608i (should be the same).