V630i Unlocking with total multiserver

[noomski]

Ok, I followed the tutorial here down to part I,7 where it says:

7. Follow the instructions given by SETool2 Lite.
8. READ THIS CAREFULLY, it is a little tricky: When a dialog pop-up, click "Yes" to remove the patch. Click "No" to add the patch. In this case click on "No" button.

However the instructions on screen say:

CID52 BYPASS PROCEDURE STARTED
Processing part1...
CSloader version:
070410 1557 HANCXC1250562_DB2020_CSLOADER_R3A009
Processing part2...
Processing part3....
Open COM port OK
OTP LOCKED:1 CID:49 PAF:1 IMEI:35194101044317 CERT:N/A
FLASH CID:52 COLOR:RED
LDR:061201 1314 HANCXC1329129_DB2020_FLASHLOADER_R2A005
Flash ID check:897E
Flash props sent ok

RESTARTING PHONE,IF PHONE NOT RESTARTS,THEN
REMOVE BATTERY FROM PHONE AND INSERT IT BACK

Open COM port OK

The phone does not restart - even with the battery reinserted. In fact it will not turn on at all anymore :(

What's gone wrong :( :(

Ok,

I've been reading around this subject for a while now and as far as I can gather it's supposed to be impossible to brick using setool. Is this correct? I only ask because I can't seem to get setool to recognize my phone at all anymore. I've tried to use my gdfs bin backup and ..........nothing. The phone won't switch on at all either. A friend of mine has the same phone so I've used it to recharge the battery to full and still nothing..

Can I restore my phone or has it completely died?