Locked k800i plz help me.

[ts013]

You didn't flash the main with SE Tool before you applied the patch.
The main get's destroyed when you brake in to flash the patch.
You have to brake in with "alternative bypass", flash your main and apply the patch afterwards.
If you wan't to apply patches in the future, you can upload the "quickaccess patch".
You don't need to flash the main after the break-in if you have the quickaccess patch.

It's not written down in the tutorial, sorry. I'll have a look at that.

EDIT: Hmm...maybe I should have pressed F5 before posting...:rolleyes:

[eraldo]

I just was kidding :)
The problem is that missing one step form that tutorial. Here is the missing step(from How to apply patches with SETool2 Lite V1.11 tutorial):

So, first follow these instructions, then do it again what you did.

I did that i got a link to a none english site that told me to do it. Altho the post was in english.

Ok justme you completly lost me.

[ts013]

And it did not work that way?!

Lost you? I don't get what you mean.

[eraldo]

No it didnt work that way i removed the usb cable took the battery out and back in and tried to turn on but nothing.
Lost me = im confused / i dont understand you.

[ts013]

So you can't even connect your phone to SE Tool when you press "C"?

Take out the battery, press start, hold down 2+5 on your phone, connect the cable and put the battery back in (while still holding down 2+5).

What does the phone do when you try to turn it on?
No response at all? Red blinking?

[eraldo]

No it connects fone but after i did what the tutorial said with the flashing and all that with the patch and vpk file the phone would not turn back on but it still connects to the pc.

[simox]

I added a DB2020 unlock patching tutorial to first post of this thread: Remove SIM-lock patch generator
So, follow my tutorial carefully. Hope it is informative enough.

[eraldo]

Thanks ill have a look now.

all that ahhh
It didnt work i did everything it said on that page but on the unlocksim step when ever i put the usb in and connect the phone by holding c it goes to file transfer without asking then after 36 secs it says 'embedded flash loader not responds'. But at least this time it still turns on after i did the other steps like quick access patch ect..

Am i doing something wrong.

[simox]

In step III. missing a little thing:
Uncheck(remove the tick from) Bypass DB2020 security checkbox.
If you already put the quick access patch, just reapeat the step III. Sorry for inconvenience.

By the way, did you installed the USB flash driver what comes with SETool2 Lite v1.11? It is highly recommended to use the latest USB flash driver.

[eraldo]

Im pretty sure i did uncheck bypass db2020 security but i havnt done that usb drive thingy will that affect anything else i put in the usb drive like a flash disk or mp3 ect..