How to apply patches with SETool2 Lite V1.11

[khli2001]

can anyone help me becauce when i connect my phone with the usb cable
my phone turns on i have press c and then connect to the pc
but it still turns on i have install the USBFlash driver but it still not working

[GinnCorvus]

can anyone help me becauce when i connect my phone with the usb cable
my phone turns on i have press c and then connect to the pc
but it still turns on i have install the USBFlash driver but it still not working

Turn off the phone, remove the battery and reinsert it after few seconds. With usb cable disconnected, press and hold "C" key then plug cable in your pc usb port, continue to hold C key until the application detect the phone. Release the C key.

[khli2001]

Turn off the phone, remove the battery and reinsert it after few seconds. With usb cable disconnected, press and hold "C" key then plug cable in your pc usb port, continue to hold C key until the application detect the phone. Release the C key.

i have done all that but it still turns on

[khawar]

i have done all that but it still turns on

Dear, you must have some problem in the phone's conecter,try to clean it and try again,if still no conection ,than you have to change the crystel IC near the conecter.

WBR KHAWAR

[khli2001]

Dear, you must have some problem in the phone's conecter,try to clean it and try again,if still no conection ,than you have to change the crystel IC near the conecter.

WBR KHAWAR

but i am working fine with setool 1.10 and other tools like XS++ FAR
just not working when i use setool 1.11
i know thats weird but thank you anyway

[endz]

i have done all that but it still turns on

i think u should reinstall the USB Flash driver from device manager..
i often get this problem too

[rtmsz25]

wrong post sry.