Simox, thanks for the link, anas sorry to be late, but I did not receive notify by email for replies of the thread.

that tutorial doesnt replies all of my questions.

please read my quoted post again and try to reply ifd possible, I'm not that newbie, so, dont reply as if I was one ;), just that there are doubts :)




Quote Originally Posted by simox View Post
I suggest you to read the following tutorial before you try to do anything How to apply patches with SETool2 Lite V1.11. And don't forget to backup your GDFS(it is very important to have a backup, otherwise you can brick your phone forever.)
You can upgrade the CID with XS++ v3.x versions. When you connect the phone to XS++ it will ask you if you want to upgrade the CID or not. Yes, after your EROM CID will be 52 you can apply the patch...

Shitblast: The generated patch is good, I know for sure because that patch was tested on sen-se forum under v2.1 development. First reflash your MAIN firmware, then read this thread How to apply patches with SETool2 Lite V1.11, and follow the instruntions. Is should work. If not try jdflasher. Just read above a few posts and you will find the link for jdflasher...

xulos: I'm working on your problem...