K750i Charging block

[blueeagle6]

Hi.

The charge-in line on the motherboard's edge connector, was damaged by my grandaughter putting the bottom of the phone in her mouth:rolleyes:

The phone was given to me by her father.

I managed to get it to charge again etc, by fitting a new charging block, and removing, and re-fitting the motherboard a few times.

There was corrosion on the charge-in connector on the board.

It seems that a large amount of the original connector is gone.

It is currently accepting the charger, and my HPM82 headset, but I feel it will go again.

I was planning on purchasing a silver conductive pen with a micro tip, to lay a new conductive surface for the charge-in line on the motherboard.

Would this approach work?
I was hoping that, this would make contact with the damaged connector, and give a nice clean conductive contact for the charging block.

Thanks.

[hELLISh]

Hope it help you...

[blueeagle6]

You are superb.

I will order the pen and do what you have shown.

Thanks again.

[shogun]

Hi I dont see why it would not work because it would give a good conductive edge like you have said. Give it a try

[blueeagle6]

I had to take it apart again, last week, because my lovely HPM-82's started playing up again after listening to music with the phone in my pocket.

It must been pulling on the fastport.

Anyway, it is working, and charging a treat again now.

But in the next couple of weeks I will be gettying that pen.

Hell, it couldn't make it any worse:rolleyes:

Thanks to hELLISh I now have another option of running a new line if the gold contact has corroded away completely by then.

Thanks to all

Greetings from Wales