Hi folks,

ok, got an old T630 id like to use again, but forgot my Phone lock code :(
Got myself a T28 Cable, downloaded the SEMC Tool 8.4 Free and installed the USBSeriel driver. When I start SEMC and select the T28 Cable, i dont get any errors that it cant find the com port, so i am presuming the driver is installed correctly. (If i try another com as to that in the Device Manager it says cant connect, so it must be ok) But, when I try to select a job and carry it out, it says Error: Phone not power up. The batt is 100% charged, but nothing happens.
Any ideas / help ?

Thx