Quote Originally Posted by ivan182 View Post
When you was flashing with "XS++" have you selected "Customize File System"?
And do you know that you must unplug your phone and take out the battery from it for 10 seconds after every flash (after flashing MAIN, than after flashing FS and than after customizing FS)?
for flashing mobile Following this steps:

1. run xs++ and press start
2. hold "c" on your mobile and connect your phone to computer via cable
3. select your fs file in flash file system and press flash
4. disconnect and exit battre for 15 seconds and repeat step 2
5. check mark customize file system and select your phone and Region
6. repeat step 4
7. select main in flash file firmware and press flash

if this post is good give thank to me.