K610i flashed and booting yet WSOD remains...

[leadweight]

Thanks for that, Satch. I have never soldered anything so small and delicate as a mobile phone PCB. This could get interesting!

[satch1234]

Thanks for that, Satch. I have never soldered anything so small and delicate as a mobile phone PCB. This could get interesting!

You are welcome,first check all contacts on PCB display connector.If some contact is black(it is burned and have oxide on it) or you can see something like white powder(water damaged) then try to clean it very gently with alcohol.If same then try to resold pins or take the phone to some private repair/unlock shop,he can change connector if needed.
Good luck,
Satch

[leadweight]

Right. I couldn't crack the phone fully open up to now because I didn't have a T6. Now that I have the phone open I think I have bitten off more than I can chew.

IMG_0520.jpgIMG_0521.jpgIMG_0524.jpgIMG_0526.jpg

I can't spot any bad contacts and even if I could they are so tiny I don't think I could do anything about them. Any thoughts?

[satch1234]

Hi,it's hard to tell from here but i would take the phone to some repair shop to resold lcd connector or replace it.You can just tell the man that you flashed phone and replaced lcd from a good working phone then he will tell you what he think about it.