W810i Problem

[namudi]

Hey i used the XS++ and Flashed my main following the tutorial eveything went ok then when i used far manager after i unpluged my phone it would not turn on anymore is there anything i can do

[spyke446]

Hmm, i'm sorry, but i'm drawing a blank on what might have gone wrong, perhaps just you missed a step. A quick solution though is using the Sony Ericsson Update Service to "update" your phone's firmware. Even if it says your phone is up to date, continue anyway. http://www.sonyericsson.com/spg.jsp?...39&numItems=18

[Khaba]

After using FAR you need to flash the main.
here are the steps you must take when customizing:
1 flash fake main
2 connect to FAR and do whatever you want to do (change drivers for e.g.)
3 flash real main back
after each step remove battery for a few seconds

[huangning]

Use phone XS and Flash main file again

[jakal121]

XS++ should also allow you to flash the main file

[Mourad120]

Hey i used the XS++ and Flashed my main following the tutorial eveything went ok then when i used far manager after i unpluged my phone it would not turn on anymore is there anything i can do

upon quiting farmanager you were doing fine ...but your phone wouldn't turn on why ???...simple ..because the break-in-loader that allowed you accessing the moblie's file system -using far -is still there ,lying , in the first part of the main phone's flash , so you need , to reflash , either rest file or the whole main file using Xs++..!

For sure, the Break-in-loader , has no purpose ,as it is , but in conjuction with farmanager would allow user to access his/her mobile's File system so as to Customize/Finalize..and even edit/add/suppress files and so on !