as i've no w880 of my own so i can't ensure the tested result.but on jdflasher there are much options than other tools.in my case w550i's FSX didn't work on XS++,but jdflasher worked not only that my k510i was patched by jdflasher following anycid method too.
So i'm telling, be careful of checking options on jdflasher.
As u said u tried to flash not applying patch.so these steps only for Flashing - Firmware/Debrand.
Shutdown phone.
Re-Insert Battery.
Oflash/Flashing for Firmware/Debranding.
- Start JDflasher.
- Press ALT+F1
- Select your db2020 in Script option, Select port as DCU-60, And select Maximum Speed 921600.
- Also Uncheck the RSA option, this can cause problems.
- Now Jump Down Into A Large Rabbit Hole. I mean Click that option .
- Jdflasher will initialize and you will will get few options on the left side. Right side is your computer’s file system.
- Now Double Click OFS..
- On right side navigate to firmware location on computer.
- Select firmware in the right side.
- Press F5.
- Click Copy.
- Then Ensure that the option flash as babe image is selected. (babe for firmwares, mbn, fbn)
- Click “Yeah Flash it”.
- Wait for flashing of all blocks to complete.
You can flash main/fs using jdflasher. To debrand the phone flash both the main and fs. Also remember after flashing FS you need to add the CDA. Download CDA and copy them to tpa/preset/custom using ofs. If you forget to add the cda files to phone fs using ofs then you will end up getting a Configuration Error.
Ofs/Customization:
- Start Jdflasher.
- Select script.
- Connect phone as told.
- Enter ofs.
- Navigate in the file system and upload files according.
- Check out the video given, it shows uploading of files to phone file system.
- Using Ofs option you can upload flash menus, acoustics, camera drivers, skins etc
- To exit from OFS you should move to Root by clicking … ! They finally click ok and exit jdflasher.