Help, my W810i will not turn on.

[Beeb]

I need help. I have a W810i CID:46. When i put it to be charged or connect a usb cable to the phone it does not "wake up" and charge or connect to my pc. If I try turning the phone on normally i get nothing. I thought that the EROM was damaged and re-flashed it along with the Main and Fs. XS++ confirmed the sofware was flashed and performed successfully.

I again came to start the phone as normal and....Nothing not a beep, flashing red light or vibration... nothing, it's the same. (I had to use the service cable to flash it).

I've flashed a few K750 and W810i's now and this one's got me stumped.

Does anyone know anything i can try? I'm starting to think it's hardware.

Thanks in advance.

[edeboi]

theres no W810 with CID46..only with CID 49

try to flash an older firmware..if nothing could help you have to send it to SE

[Eddie]

take it to the service center coz it seems hardwear problem might the screen is gone so the better way to take to the proper DOCTOR ;)

[Beeb]

Sorry my mistake - I mean CID:49.

The screen is fine i replaced it myself. When i first got the phone i turned it on and the broken screen (at the time) showed signes of life. I took several attepts before that happened.

I think it's been dropped and the solder surrounding the chips N2802, V246, B2200, D2230, X2600 and N2600 have been making intermittant contacts.

When i get the chance i'll check and let you know the results.

Thanks

[Alireza114]

u can falsh with older frimware

[Khaba]

so the phone was damaged when you got it? It's better to take it to a sevice center, it might have other hardware problems.

[HBMariu]

Did you had it finalised???I had the same because I forget the finalising then I do it and it workes fine.