Flash K750c (chinese) to W800 (also chinese)

[hyperion17]

Try "GFlash":
- make sure that your battery is fully charged! (At least 85% up)
- Prepare all the correct main and fs files (should be same versions and phone models)
(main red cid36 and fs red cid36)
- Much better if, before you start Gflash that
your phone already turned off and dettached battery.
- Avoid disconnecting the phone while in flashing process!
FLASHING EROM - BROWN CID36 TO RED CID 36 ONLY!
Under the "REPAIR/GDFS/PATCHING" tab,
enter the RED CID36 RAW erom file (make sure it's RAW)
ex. RED_CID36.Erom (download from topsony)
put the battery back in. (do not connect your phone, not yet!)
then click the "REPAIR/GDFS/PATCH" button
you will get this message:
GFlash version 2.0 beta 6
**** REPAIRING/PATCHING STARTED ****
Turn off the phone.
Hold "C" button and plug USB cable.
as instructed, hold the "c" button and plug it to the usb cable.
(release "c" button only when flashing process is already starting)
and just wait till it's done.(in just a minute or less)
do not shut down Gflash.
disconnect your phone from the usb cable,
but DO NOT TURN IT ON!
remove the battery for a few seconds.
place it back in. (do not connect the cable, not yet!)
FLASH W800_CID36_RED FIRMWARE with Gflash, or XS++