XS++ stuck

[wahoo98k]

so I am having severe issues w/ my k800i, Wotan said it repaired eprom, then when i let it sit and then connected it again it now gives me a SEMCSEC error #3. I have "successfully" flashed it in setool, but it wont boot, ive also flashed in FAR/JDF. XS++ will hang at the "protocol" level. heres a paste of my log.


14:16:10| XS++ v3.1 (Darwin) Ready !
14:16:19|
14:16:19| Attempting to open the interface...
14:16:19|
14:16:19| TURN OFF PHONE!
14:16:19| Hold 'C' button on phone and connect phone NOW.
14:16:19| You have 30 seconds...
14:16:19|
14:16:28| Baseband ID: 9900
14:16:28| Protocol Version: 3.1


any help?

[hyperion17]

Post also an identify log from Setool.

[wahoo98k]

Welcome to SEtool2 ( LITE edition ) v 1.10
supported DB2010/DB2012 CID49/50/51/52, DB2020 CID49/51/52
Loaded 51 flash descriptors

if you like LITE edition - please visit http://www.setool.net and buy FULL.

ChipID:9900,EMP protocol:0301
BOOTROM MODE DETECTED
Speed:921600
Flash ID check:2019
Flash props sent ok
OTP LOCKED:1 CID:49 PAF:1 IMEI:35170701230214 CERT:N/A
FLASH CID:49 COLOR:RED

Model:K800i
MAPP CXC article: R1GB001 prgCXC1250214_CHINA_WI
MAPP CXC version: R1GB001
Language Package:APAC
CDA article: CDA102568/101
CDA version: R6A
Default article: cxc1250490
Default version: R1GB001

Operator: 000-00

Elapsed:6 secs.