Patching CID53 (DB2020) and any CID (DB2010,DB2012)

[ricksterm]

get the simlock vkp generator here : Remove SIM-lock patch generator - Top Sony Forums

I think that only goes up yo CID 52 and my phone is a 53 :(

[riders4sia]

well, if you look thoroughly, you could find it. here it is, it's better to upload here

[riders4sia]

Does any have anyCID for k810i R8BA024?

[Megalithic]

Thankyou, my w610i is now unlocked (db2020 with cid53), guide was a little confusing to follow, all worked fine once i replaced the qa2020 file in jdflasher with the one from anycid. flash seemed to take a lot longer than normal in bflash but it worked and now i can use my new sim in my old phone :D:)

[xxxx0xpur3]

why everytime when i run EXECUTOR it says "operation failed" and when i go on "bflash" an error massage comes up and my phone turns on for some reason help! plz btw i am using a k770i

[MrPham]

Thank for all, guys :)

I'll apply with my w200i RED CD53 :(

[basco14]

Help me please with K810 R8BA024 Orange firmware, there is no files in anycid archive for this firmware

[galit]

need w850cid53 firmware please help me

[SoapieSam8]

So I'm brand new to this phone unlocking malarkey. Therefore I am falling at this first hurdle. I have downloaded all it said in the "you will need" section.:

1. With your MAIN make rest files with mkrest2 (you find him in /Far/Plugins/jdflasher/rest/mkrest2)

a) What is my MAIN?
b) Where is/Far/Plugins/jdflasher/rest/mkrest2?

I'm trying to reset the phone lock code, 4-8 digits, on my SE K800i, with CID53. Any replies, or anyone who wants to add me on msn and help would be greatly appreciated!

[live1052]

Your MAIN is one of the 3 files you will need to upload to your phone. One is MAIN, one is FS and they both must be added in the oflash section of FAR, and then the next is the Cust files which give your phone its regional settings, and you upload the entire folder containing these files, called tpa, into the ofs section of FAR. To get to the mkrest2 program, go into your FAR file, then the plugins file, then the jdflasher file, then the rest file and then drop your MAIN file on top of the mkrest2 icon thats there. That will spit out a new file into that folder, which is your rest file.

Im still learning too, buddy, and half the time, all people do here is send you a link to another thread which youve already read and didnt work. Im still not there yet but Im getting there.