XS++

[simox]

What about battery? It has enough charge?

[se7enofnin]

Yes it has a full charge when I try it.
I always charge it fully before doing anything.
Derek.

[se7enofnin]

I have gone back to setool and reloaded the drivers and I got phone specs:-
CID52 - DB2020 - colour red.
I then went to an instructional video and tried to back up the GDFS and now the phone will not link to setool.
I tried to turn the phone on and it will not start.
Any ideas where I go next please?
How do I get phone to switch on?
How do I get the phone to link to setool again?

HELP!!


Derek.

[SeaMonkey]

Try like here plz help... k810 is dead what can i do ? - Top Sony Forums and follow every step and DON'T turn on until you done all

[se7enofnin]

Hi Seamonkey,
Did what you said and went to the link you gave me.
Connected to setool ok.
Then went to XS++ and held 'C' button ,plugged in and got
error: cannot open phone communication port.

What can I try now please?

Derek.

[SeaMonkey]

You have problems with conection - clean phone connector,change USB port and reinstall drivers and than try to connect to XS++ or your USB cable have problems

[azncheng]

i had the same problem,,,,try presing 2 and 5 togehter while pluiggin it in

[se7enofnin]

Tried all the above but it would not work for me so I found SEUS and updated. Now I have got CID 53 and I am not able to unlock it, unless you know any better!
At least the phone now works, suppose that is a consolation.:(