K800 problem

[swindlerz]

phone doesnt turn on. can only connect by holding 2+5. i tried to use setoolite to identify and dc usb without reinserting battery so i can hold c whlist plugging usb but still cannot connect to xs++ to reflash it. if i reinsert battery after identify. holding c doesnt work since comp doesnt detect it.

[jasmin]

Change usb port and then install this:

USB Flash Driver Installation - Guide

Then connect to xs++ and copy here your phones log without IMEI number.

Have a nice day

[swindlerz]

Welcome to SEtool2 ( LITE edition ) v 1.11
supported DB2010/DB2012 CID49/50/51/52, DB2020 CID49/51/52
Loaded 51 flash descriptors

if you like LITE edition - please visit Index of ./ and buy FULL.

ChipID:9900,EMP protocol:0301
BOOTROM MODE DETECTED
Speed:921600
err: 45 (13)
loader prologue returns invalid status
Can't load ID loader !
Elapsed:0 secs.

via setool lite holding 2 and 5.

usb drivers are installed properly since i can connect holding c via another k800i.

i tried following this
Top Sony Forums - View Single Post - plz help... k810 is dead what can i do ?

but on part 3:
3. Hold 2 and 5 together and in the meantime put the USB cable.
When hear that sound (though that connects USB flash memory) disconnect USB cable, reinsert battery and do NOT turn on phone!

if i reinsert battery, it doesnt work because xs++ doesnt dectect anything since computer doesnt make any sound once connected.

[swindlerz]

could it be damged because it dropped in water?
ive seen this phone before it worked when it dried just that the led light of the screen was dead so it was too dim.
but after 2 weeks the phone was given to me for free and i tried flashing it since it didnt turn on.

how do i replace the flash chip?

[philzfog]

err: 45 (13)
need to replace the flash chip as it is faulty