My k810I wont connect

[flewrida]

Hello
I have an K810I from sweden and i really want to unlock it but i have tried with installing usb flash device and connect it to XS++ but the program sais
00:48:45|
00:48:45|
00:48:45| TURN OFF PHONE!
00:48:45| Hold 'C' button on phone and connect phone NOW.
00:48:45| You have 30 seconds...
00:48:45|
00:49:15| Error: Cannot open phone communication port
00:49:17| Disconnected... Unplug the phone

what's the problem

[johnliang]

1. You need to install the usb driver correctly before you use xs++
2. When you connect the phone to the computer , keep pressing "c" until the phone is detected .

[flewrida]

Thats what im doing everuthing is correct installed and i am keeping C pressed but after a while the phone goes on and is ready to import files from the computer

[simox]

In Remove SIM-lock patch generator - TopSony Forums thread follow the section: How to connect the phone to flashing/patching tools.

i am keeping C pressed but after a while the phone goes on and is ready to import files from the computer

Usually this is a driver, or a contact problem. First try to clean the phone port and the cable connectors.

[riders4sia]

yes really, download the SEMC driver and install it, now switch off your phone, remove your battery for 5 sec., reinsert it again, press and hold c and connect your phone and press "connect" on XS, it will connect for sure. have a nice day

[nick87]

it is a connection problem, try to clean phone's slot for da DCU, or try to move it a lilbit when connecting the cable

[yayo830]

did this happen right after U did the "USB drive" procedure? or you actually have the phone connected before but now it won't connect again?

If this happen right after you did the "USB driver" procedure, then it maybe the "cable connection" problem. If you actually had it worked before but now you cant connect, then ill say try to reflash the phone, there is problem some problem with the software in the phone.

Also, check your phone's battery. make sure its fully charged or at least have power to run some modification and so on...

[tonywong41]

try seTool

[riders4sia]

download setool1.1 and extract it anywhere you want, try to connect your phone holding c after reinserting the batt, you will hear a sound from the computer, a found new hardware device will pop up, click on advance options, and browse for directory called driver in setool folder and select the driver folder and click ok, it will install the SEMC usb driver, after that you will surely get it connect. have a nice day

[kelvin2009]

try to press 2+5 instead of pressing C