my PC has turned off unexpectedly while flashing!!!

[dicom]

DCU-60 comes with newer phones(fast port) - K500 uses DCU-11...
some more information about program's describtion:
"semc tool 8.4 free(cracked)":
Switch phone ON
Get phone info
Flash CID: 90 (must be 29)
Phone KEY: ZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZ ZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZ
ERROR: 305011
"setool2 cracked" hangs and hangs my com port.
Sonics:
Lante Sonics is Ready..
Device ready.
Powering phone...
Warning: chip id read error.
Unknown phone, that's an error.
Time elapsed: 2 secs
"XS++ v3.2":
Attempting to open the interface...
Baseband ID: 5A5A
Protocol Version: 90.90
Speed set to 115200
Warning: IMEI name does not match GDFS name (IMEI:NULL GDFS:n/a)
...using GDFS name
Restarting phone - please wait...
Binary acknowledge failed with: 00
Failed
Failed
Baseband ID: 5A5A
Protocol Version: 90.90
Speed set to 115200
Phone has restarted successfully...
Profiling SEMC phone...
Platform: Unknown
OTP CID: 0
EROM CID: 1515870810
EROM Color: Unknown
IMEI: n/a
Phone ID: n/a
Region: n/a
CDA: n/a n/a
Firmware Version: n/a
EROM: n/a
Ready for operation!
Sorry, your phone is NOT SUPPORTED
Error: Cannot send flash loader
Error: Flashing failed
Disconnected... Unplug the phone
---- i'll remind that this happend when my pc turned off unexpectedly during the flash, everything was ok before... turned off because of bad drivers, as i did it very long ago i couldn't remember wich one of the drivers is ok :-(