K610i dead after w660 flash

[heyikes]

Hi,
ok i pretty new to this stuff so if there are any questions anyone can ask that might help me i'm gonna be online for the next 17 hours.

I have a k610i that i flashed with w660 firmware. Everything was going fine until i hit the USB cable and disconnected the phone while applying the simlock patch with setool2 lite.

Now the phone wont turn on heres the setool log as it stands at the moment.

Welcome to SEtool2 ( LITE edition ) v 1.10
supported DB2010/DB2012 CID49/50/51/52, DB2020 CID49/51/52
Loaded 51 flash descriptors

if you like LITE edition - please visit Index of ./ and buy FULL.

ChipID:9900,EMP protocol:0301
BOOTROM MODE DETECTED
Speed:921600
OTP LOCKED:1 CID:51 PAF:1 IMEI:35463801221188 CERT:N/A
FLASH CID:52 COLOR:RED
LDR:061201 1314 HANCXC1329129_DB2020_FLASHLOADER_R2A005
Flash ID check:2019
Flash props sent ok
CSloader version:
070410 1557 HANCXC1250562_DB2020_CSLOADER_R3A009
loader startup: executed
wrong response, break.
failed, that is fatal
Elapsed:192 secs.

Both Setool and XS++ detect the phone but i have no idea what to do to in order to get it up and running again. If anyone has any constructive advice PLEASE throw it in my direction.:(

The Yikes

[WorthyStar]

Reflash your k610i firmware and cust pack if that does no good say goodbye to your phone.

[simox]

First reflash the MAIN firmware, and turn on the phone to make sure that it works. Then apply the patch(es) again.

[strizlow800]

I would suggest you to full flash the firmware. I mean, flash MAIN, FS and then customize. Turn on the phone and make sure it is in full working order. If so, patch it with correct patches. :)