w810i XS++ 3.1 flashing woes

[airfoil]

No luck with SETool Lite either, I'm receiving errors:

Welcome to SEtool2 ( LITE edition ) v 1.11
supported DB2010/DB2012 CID49/50/51/52, DB2020 CID49/51/52
Loaded 51 flash descriptors

if you like LITE edition - please visit Index of ./ and buy FULL.

Elapsed:2 secs.
ChipID:8040,EMP protocol:0301
PHONE IS RED RETAIL PRODUCT
FLASH CID detected:49
Speed:921600
OTP LOCKED:1 CID:49 PAF:1 IMEI:35906100771302 CERT:RED
ldr_on_ldr hdr no ack (10)
Elapsed:7 secs.
phone pre-boot failed,possible RECOVERY needed.
Abort all operations.
Elapsed:3 secs.
ChipID:8040,EMP protocol:0301
PHONE IS RED RETAIL PRODUCT
FLASH CID detected:49
Speed:921600
loader header not accepted
phone pre-boot failed,possible RECOVERY needed.
Elapsed:6 secs.

ChipID:8040,EMP protocol:0301
PHONE IS RED RETAIL PRODUCT
FLASH CID detected:49
Speed:921600
loader payload not accepted
phone pre-boot failed,possible RECOVERY needed.
Elapsed:9 secs.
ChipID:8040,EMP protocol:0301
PHONE IS RED RETAIL PRODUCT
FLASH CID detected:49
Speed:921600
err: 36 (30)
loader prologue not accepted
Can't load ID loader !
Elapsed:5 secs.

Any more tips shall be greatly appreciated. Please help!

[schmarakel]

Can you post the log when you connect it with XS++3.1