Printable View
Hello
I have come across some patches that give me a message when i try to install them onto my K800 with Setool2.
Like this GFX patch i made, when im installing it to my phone with setool it gives me a message "Some patch values differs - continiue YES or NO"...
That is after i have pressed to go ahead and patch.
What does that mean?
Can i harm the phone in any way if i go ahead and press yes to patch?
Thanks!
i tried to install the patch anyway a few times and i stuck on white screen and need to preflash na main :)
It will not harm your phone, but the patch might not work, some vkp patches if the values are different, may damage your phone, what patch are you trying to write??
He said the GFX patch
Yeah it is a GFX patch that i made, i dont think its the patch itself because i have made GFX patches before that have worked.
It have to be the images that are causing it to react..
I think the images are a bit smaller than the original ones.. maybe that is the cause?
@BenyBoy3: How do you mean, you wrote that it wont harm the phone but then you write that it might damage it?
As i wrote its a GFX patch (xxxx.vkp) made with "Image Tool DB2020".
this msg have 2 REASON:
1) your patch is incorrect(may internal bits is incorrect)
2) you dont delete old patch.it hasn't ANXIETY.if your patch is correct it replace
Important :
If pach was incorrect it dont damage phone just you must remove it .
Even if i reflash na main it still says this message about the values
Can be two problems:
1. The patch is corrupted(not working)
2. The patch isn't for your firmware...
I did this so many times.
Luckily it doesn't kill my phone!
I'm using w810i
patches should conform to your firmware version.
probably the problem is that you already have a patch that uses the same donor images as the one you want to put in the phone
but if you get the same message, after you reflash (and put "new" quickacces patch)- i don't know what it is