help me with FAR !!!!!!!

guys plz help me i m not able to use ....far manager(before ptching mov_sys to other i was able to use FAR )

using w810i

fst when i m using it opening it .....it detects
then two option cums

FLASH
FS


but after when i m clicking FS my phone gets disconnected voice and it automatically open ..FILE TRANSFER MODE i did install again ..FAR and tried but the same thing ...


ya and i want to let u know that i did patch move_sys_to other ....and i m write now using method of changing all drvers without using FAR manager .... i mean by using FILE TRANSFER i hav sys in other of phone memory

what to do i want to use FAR Manager .... ??? any way out plz tell ppl


tks ppl

turn the phone off, remove the rim, put the battery back in place, hold c button when far ask you to do that (after you enter the se plugin)

open xs++ and in the main firmware put the rest(fake) file of w810i. then it will be able to go into farmanager

and ya after modifying thing through farmanager install the orignal w810i firmware again. hope this helps

This might not work...my brother has a w810i...with the same problem. I tried what waleedhk said, but the problem persists. I think it can be done with xs++, but you have to make a custom pack or something...I'm not sure about this...didn't test it.

yes, try again with xs++

the phone should enter normally into the FS if you use the SSW file! I had this problem because I forgot to flash the fake main.

Help I can not open fs files to w550i cid 49 red !

i have the same problom...i dond`t now what to doo to..

make sure u back up gdfs

Is this safe to do?

Yes, it is important but everybody rarely does so. :) I propose to use SE TOOL. It is more safe. :) Remember about copy of GDFS (backup). :)

flash the fake main and then enter the FS if using SEFP. but you will lose all your patches because patches are stored in the Main. if you use JDFlasher though, you won't need to use a fake main and you won't lose any patches, etc.