Camera not working K810 (K800)

Hi!

Got a problem with the camera. Have flashed to K810 and when finished
it worked as expected.

But now, when i remove the lens cover the screen gets white, keypad lits up
the all gets black. A few seconds later the screen and keypad comes back as supposed to, if the cover is closed. Else it does the same procedure again.

Re flashed the phone but it didn't helped.
But if I'm using the camera from face Warp it works.

Any suggestions to a solution?

I've changed the font and menu, but that shouldn't matter, right?

Try start camera manualy, when the cover is open.

To bad, but that didn't worked. Same symptoms as described above.

Better that you flash it back to k800i or flash it again with k810i software.

Nice day

I've tried to flash it again with K810 firmware, but it didn't help.

Try flash to k800 soft and then try your camera.

did you use the k810 keys patch before you flashed the k800 with k810 firmware?

if not, then try following the guide in esato forum about converting k800 to k810. maybe you missed some steps while flashing it.

[QUOTE=louis*cyphre;48512]did you use the k810 keys patch before you flashed the k800 with k810 firmware?QUOTE]


Whats that? I flash my k800 with k180 firm without any patc and it work perfectly.

Yes, i used the key patch.

debeliz -> The patch is for some keys to be lit up in camera mode, which not are working after k800 k810 update.

Quote:

---

Originally Posted by XepheX

Yes, i used the key patch.

debeliz -> The patch is for some keys to be lit up in camera mode, which not are working after k800 k810 update.

---

But thats are only lights, that should not have matter with camera.
Maybe this didn't software problem?

I'm sure that this is a software problem though i can use camera from face warp application.

Did you flash to k800 soft?

I will do that later this evening, when my kid are in bed ;)

Edit:

Flashed it with the K800 firmware now and it worked. Now i just have to change the font and menu again :)

Thanks for your time!

I have now discoverd what it is!

When i change the save path from phone to memorystick then i goes white as in my first post. After that you pop out the M2, start camera wich now work though it complains that thers isn't any M2 in the slot. Change to save at phone then i work again.

Strange isn't it?


Edit 3:

Formated the M2 and now it works as it supposed.

Maybe upgrade to original firmware and send it to sony?

same probs in firmware R1ED001 flash ur firmware or change it

you first test hardware camera then try flash phone
goodluck

Before flashing u would have charged your battery, because battery plays vital part, if it is weak then u can't use camera. its that simple, and now u flashed and now u need to successfully flash first, becuse u already flashed. see results with camer like i mentioned. Good luck!

hey guys my k800 camera hangs the phone what is this hardware issue or software, phone also hangs on service test camera, even on flash discharge in service.. changed nearly all firmware flashed to all fs available but problem still persist ...any one can help on this :-(

Look flash with firmware, that you have when you bought your phone and take it to service center.

Nice day