W580 after flashing is not working

I was flashing my phone to be able to unlocked but without success. I used the generic main file then the FS americas 1 but then I start having issues with IMEI and the GDFS without being able to recover. I decided to download the GFDS and installed. Now the phone won't even turn on. Is only flasing a red led inside and no signals of life. It there any way to recover it.

22:47:45| Baseband ID: 9900

22:47:45| Protocol Version: 3.1

22:47:46| Warning: IMEI name does not match GDFS name (IMEI:NULL GDFS:W580)

22:47:46| ...using GDFS name

22:47:46|

22:47:46| Profiling SEMC phone...

22:47:46| Platform: DB2020

22:47:46| OTP CID: 51

22:47:46| EROM CID: 52

22:47:46| EROM Color: Red

22:47:46| IMEI: 01157200xxxxxx

22:47:46| Phone ID: W580

22:47:46| Region: CINGULAR

22:47:46| CDA: CDA102774/102 R25A

22:47:46| Firmware Version: R8BE001

22:47:46| EROM: R3A022

22:47:46| Ready for operation!

THanks

did you create a gdfs back-up of the phone??? or you just download a gdfs from internet?.. if you installed a wrong gdfs, sorry to say that your phone is already dead.. i think the erom of your phone is damage... you need to repair it,, i suggest you to use wotanserver or kulankendi... just search it on the internet...

Thanks, it was damaged after I did the first flashing and it was giving me a lot of error. I tried to used my back up but without success. In my last attempt to recovered the phone, I dowloaded a w580 gdfs with blank info but dies after that. I will see if I my use the wotanserver.

Thanks again

did u right a diffrent gdfs to it ? if so ur phones dead for now but it can be fixed show me a read out from se tool lite please

if I tried to unlock/repair and reading GDFS this is the message that appeared by holding 2&5 since if I touch c it will flash the red light immediately:


ChipID:9900,EMP protocol:0301
BOOTROM MODE DETECTED
Speed:921600
OTP LOCKED:1 CID:51 PAF:1 IMEI:01157200437535 CERT:N/A
FLASH CID:52 COLOR:RED
LDR:061201 1314 HANCXC1329129_DB2020_FLASHLOADER_R2A005
Flash ID check:897E
Flash props sent ok
CSloader version:
070410 1557 HANCXC1250562_DB2020_CSLOADER_R3A009
loader startup: executed
loader GDFS startup: executed
smth wrong with usercode reset,error is: 1
Elapsed:73 secs.
Will backup GDFS now.
ChipID:9900,EMP protocol:0301
BOOTROM MODE DETECTED
Speed:921600
OTP LOCKED:1 CID:51 PAF:1 IMEI:01157200437535 CERT:N/A
FLASH CID:52 COLOR:RED
LDR:061201 1314 HANCXC1329129_DB2020_FLASHLOADER_R2A005
Flash ID check:897E
Flash props sent ok
CSloader version:
070410 1557 HANCXC1250562_DB2020_CSLOADER_R3A009
loader startup: executed
loader GDFS startup: executed
stated number of vars:1293
Found:1030 variables
Found:263 variables
GDFS read all done, GDFS_01157200437535.BIN written
Phone detached
Elapsed:80 secs.

Regards

smth wrong with usercode reset,error is: 1
means u have a diffrent gdfs on the phone
and the unlock repare button is for se tool box users
do u have a gdfs back at all from that phone

Yes indeed I have it but it does not let me installed it. Did you have or know about another software that may force the reprograming

THe mistake that I make was that when I was having the configuration error message whenever I boot the phone with the SIm card, I read that GDFS was corrupted and in desperate attempt to recover the Phone I tried to installed another GDFS from another phone but exchanging the IMEI. SInce then the phone is locked and only activating the red flash.

u got configuration error becuse u didnt flash a custom pack to it that would off been so easy. if u have the gdfs back up and ur haveing truble righting it back use se tool light add the gdfs back uo to the mics box then press wright gdfs and concet ur phone by holding the 2 and 5 button not the c button this should solve it if not let us know

THat's I did and this is the message I got:

ChipID:9900,EMP protocol:0301
BOOTROM MODE DETECTED
Speed:921600
OTP LOCKED:1 CID:51 PAF:1 IMEI:01157200437535 CERT:N/A
FLASH CID:52 COLOR:RED
LDR:061201 1314 HANCXC1329129_DB2020_FLASHLOADER_R2A005
Flash ID check:897E
Flash props sent ok
CSloader version:
070410 1557 HANCXC1250562_DB2020_CSLOADER_R3A009
loader startup: executed
loader GDFS startup: executed
Will write GDFS now.
will write 538969343 variables
gdfsWrite err:A,block:20,unit:2002
Exception in GDFS write. maybe bad gdfs file.
done
Failed.
Elapsed:76 secs.

Can is possible to reconstruct a GDFS in case my back up is also damage?

As I suspected, the GDFS back up was damage and is not installing due to a failure. I downloaded a GDFS from the topsony site and this the message:


ChipID:9900,EMP protocol:0301
BOOTROM MODE DETECTED
Speed:921600
OTP LOCKED:1 CID:51 PAF:1 IMEI:01157200437535 CERT:N/A
FLASH CID:52 COLOR:RED
LDR:061201 1314 HANCXC1329129_DB2020_FLASHLOADER_R2A005
Flash ID check:897E
Flash props sent ok
CSloader version:
070410 1557 HANCXC1250562_DB2020_CSLOADER_R3A009
loader startup: executed
loader GDFS startup: executed
Will write GDFS now.
will write 1288 variables
done
Phone detached
Elapsed:98 secs.
But this GDFS does not work for my phone

ur phone can be fixed with D-Ultimate Unlocker cost ten euros to do it if u buy a log then give me a shout will run u though it

I bought it, what should I do?

right now u have to wright the clean gdfs u downloaded from the down load area with se tool holding the 2and 5 button like u did then close se tool and open D-Ultimate Unlocker then make sure u put ur user name and pass word in ie (user***) then save settings press check creidts to mske sure it working if so then press restart the pick ur phone from the list then pick full unlock and reset sec units make sure both boxes are ticked top right hand side then take the battry out off ur phone put it back in hold the 2 and 5 button and plug ur usb lead in then follow what it tells u in the box when u have done this ur phone ill be fixed and unlock but u may still get the same err that u had b4 so then pick a custom pack for were u live kep it in rar fourm and flash it to ur phone with se tool lite if u get stuck just ask

Thanks it works, but now I went back to the configuration error message when I put the sim card. I am from PR and the phone is from ATT, I tried several custom package before so I would like to make sure which one to use.

I dont think there is one in the download area att files are realy hard to find

I found it is W580i_CDA102774_102_R25A_ATT_USA but I can't find the way to install it using the SE tool. I tried X++32 but it have its own packages. Can you let me know the procedure to do it?

add it in rar fourm to the mics box then press flash

Thanks a lot, I start looking last night on all the thread and found the link that explain it.
Flash your phone using SETool 2 Lite - Top Sony Forums
Thanks you again, the phone is finally working.

I have another question. If I program another w580 with the generic Main, FS and the zip file, I will not unlocked. Is there any other thing to unlocked for free or should I need to buy another log and use d-ultimate unlocker

IF U USED d-ultimate unlocker BTO FIX UR PHONE IT SHOULD BE UNLOCKED :confused:

Thats ok is when I used the program with another phone no previous one that is already unlock and fix.

guys i need help Please!! i debrand my phone but i want to rebrand it (for warranty reasons) and im guessing to rebrand it i need fs and main of att right? so i found the custom pack of att but the fs and main i cant download because it ses i need to have a premium account could anyone help me please to tell where i can download em or something :) thnx

Send me an email and will send it to you. Follow the link on the second page to use SEtool

when you originally debranded it did you make a back up of your gdfs?

hey guys!!!


i am having the same problem as you.... or HAD. i was using setool 2 lite, and then afterwards, it all worked out, and i detached the phone, and the screen was all messed up, the resolution was too big for the phone... i was wondering if you could send me the d ultimate unlocker program plsssssss =[

you can download it from the download section google it