K800 looks fine, but it cannot be turned on and connected by XS++, Setool, FAR.
With Setool first time was able to connect with 2+5, but i tried one more time, then many times and nothing. Possible to do something?
Printable View
K800 looks fine, but it cannot be turned on and connected by XS++, Setool, FAR.
With Setool first time was able to connect with 2+5, but i tried one more time, then many times and nothing. Possible to do something?
ChipID:9900,EMP protocol:0301
BOOTROM MODE DETECTED
Speed:921600
Flash ID check:2019
Flash props sent ok
OTP LOCKED:1 CID:49 PAF:1 IMEI:3517070xxxxxxx CERT:N/A
FLASH CID:52 COLOR:RED
no ack during gdfs_readvar !
Can't read SCRC unit
Tried with a full flash ( main , fs and custom file ).
Have a nice day
no ack during gdfs_readvar !
Can't read SCR
try a full battry and that phone wont charge that battry
I can't do a full flash. What about test points?
AFAIK "Can't read SCRC unit" means your GDFS is damaged or corrupted and you must repair it with Setool Box .
Can I do testpoint for free? Tell me please, if it's possible to do.
Hellow guys i also have a similar problem.when i flushed my blinkng k800i which i changed from CID49 to CID52 it stopped the white screen blinkng and now blinks 6times in infrared port! Should i use setool if so how can i run it on my pc? Please help.
Read this plz help... k810 is dead what can i do ? - Top Sony ForumsQuote:
Originally Posted by snowflake
silent move any ideas what caused the problem because if phone dropped in water the phone will be broken but you still can connect via 2+5 but its still broken
I've seen an K800 repaired
try with the DaVinci Flasher and press C+2+5; the rest will follow.
next week I will post the rest of the story