V800 @ Z800: now phone is dead !

If you can`t do it and you tried every thing possible, then you should take it to service center.

Nice day

Quote:

---

Originally Posted by ax89

Hello guys,
I have a SE V800 flashed to Z800 with SeTool 2: now this phone is dead. I've tried everything to restore it, but, unfortunately, without success. Flashed many times, rewrited GDFS, EROM, tried Unlock/Repair and this damned phone still won't startup. Display lights for a fraction of second and before it does nothing, stays off. What could be happened? There is a chance to repair it?
Thanks in advance to all.

---

Did you used SeTool2 (cracked by Ortica v0.91373)? NOT setool2 lite...right?
The original firmware was CID 29 or CID 36? Is necessary update the CID with the patch before flash.

Quote:

---

Originally Posted by GinnCorvus

Did you used SeTool2 (cracked by Ortica v0.91373)? NOT setool2 lite...right?

---

Yes, right.

Quote:

---

Originally Posted by GinnCorvus

The original firmware was CID 29 or CID 36? Is necessary update the CID with the patch before flash.

---

Original firmware was CID36, so I think that it's not necessary to update CID.

Quote:

---

Originally Posted by ax89

Yes, right.



Original firmware was CID36, so I think that it's not necessary to update CID.

---

So, i don't know... Try a full flash with SEMC v8.4.

Flash failed. Here is SEMC-Tool v8.4 log:

Switch phone ON
Get phone info
Flash CID: 36
Phone KEY: A1_DB2000_36_RED
ERROR: 305010

Is possible to fix this damned GDFS with any solution without take the phone to a service point, because now it is no more under warranty?

try fash it with xs++ 1.5

Some (good?) news:

I have flashed the phone with TMS 2.45 client after tried to repair it using "Repair EROM" & "Recover Phone". In the end of process TMS has stopped in "Customize FS" and "Finalization": now phone doesn't start, but flash LED lights until I press the power on button. Is this a good signal from my V800?

Up...please help me.

No one can help me ?!?