XS++

I have gone back to setool and reloaded the drivers and I got phone specs:-
CID52 - DB2020 - colour red.
I then went to an instructional video and tried to back up the GDFS and now the phone will not link to setool.
I tried to turn the phone on and it will not start.
Any ideas where I go next please?
How do I get phone to switch on?
How do I get the phone to link to setool again?

HELP!!


Derek.

Try like here plz help... k810 is dead what can i do ? - Top Sony Forums and follow every step and DON'T turn on until you done all

Hi Seamonkey,
Did what you said and went to the link you gave me.
Connected to setool ok.
Then went to XS++ and held 'C' button ,plugged in and got
error: cannot open phone communication port.

What can I try now please?

Derek.

You have problems with conection - clean phone connector,change USB port and reinstall drivers and than try to connect to XS++ or your USB cable have problems

USB Flash Driver Installation - Guide

Have a nice day

i had the same problem,,,,try presing 2 and 5 togehter while pluiggin it in

Tried all the above but it would not work for me so I found SEUS and updated. Now I have got CID 53 and I am not able to unlock it, unless you know any better!
At least the phone now works, suppose that is a consolation.:(

Unlocking only against payment. Look in my signature.

Have a nice day

did u remove the battery and put it back again after u've backup the GDFS

try this
Patching CID53 (DB2020)DB2010,2012 - Top Sony Forums
please always use the thanls button