i'm tryng to flash my w550i but now it is dead

i was flashing my w550i,
i had install the usb flash drivers,then
i use xs++for flashing my phone then it halt in this way

19:45:51| XS++ v1.2 Ready !
19:45:59| Attempting to open the interface...
19:45:59| ++++++++++++++++++++++++++++++++++
19:45:59| Turn off phone
19:45:59| Hold C Button on phone and connect phone.
19:45:59| You have 30 seconds.
19:45:59| ++++++++++++++++++++++++++++++++++
19:46:06| PORT STATUS: ACTIVE
19:46:06| Baseband ID: 8040
19:46:06| Hardware Platform: db2010 Marita compact
19:46:06| Protocol Version: 3.1
19:46:06| Sending loaders\db2010_cid00_prodid_p3k.bin...
19:46:06| This is a PRODUCTION_ID loader
19:46:06| Activating GDFS...
19:46:07| phone name detected
19:46:07| ++++++++++++++++++++++++++++++++++
19:46:07| PHONE INFO
19:46:07| ++++++++++++++++++++++++++++++++++
19:46:07| DBID: db2010
19:46:07| OTP CID: 49
19:46:07| EROM CID: 49
19:46:07| EROM color: Red
19:46:07| IMEI: 35744400xxxxxx
19:46:07| Phone: W550
19:46:07| Operator: EMEA_6
19:46:07| CDA: CDA102415/89 R3A
19:46:07| Firmware: R4CB020
19:46:07| EROM: n/a
19:46:07| ++++++++++++++++++++++++++++++++++
19:46:07| Ready for operation!
19:47:07| +++ Flashing breakin...
19:47:07| Sending loaders\db2010_cid49red_flash_r2a003.bin...
19:47:08| This is a FLASH loader
19:47:08| Sending flashfile loaders\jhf0A.bin
19:47:08| 1 flashblocks
19:47:09| Done flashing
19:47:09| ++++++++++++++++++++++++++++++++++
19:47:09| Disconnect phone from USB-port and wait for
19:47:09| further instructions.
19:47:09| You have 8 seconds.
19:47:09| ++++++++++++++++++++++++++++++++++
19:47:17| Open the battery-cover and reinsert the battery.
19:47:17| Hold C Button on phone and connect phone again.
19:47:17| You have 30 seconds.
19:47:17| ++++++++++++++++++++++++++++++++++
19:48:12| +++ Sendinging shutdown signal to phone...
19:48:14| Shutting down...


and then i disconnect my phone's usb,
then i try to switch on my phone it does not switching on what to do now!!!!!!!!!!!!

You Should Have Used Latest XS++ 3.1 Rather Than 1.2.
However Is There A Red LED Blinking In Infra Port When Turning Phone On?

did you reinsert the battery??

what firwamre were you flashing it with and why, (like derbanding, upgrading firmware, etc)

Quote:

---

Originally Posted by mohdumer

You Should Have Used Latest XS++ 3.1 Rather Than 1.2.
However Is There A Red LED Blinking In Infra Port When Turning Phone On?

---

no there is no red LED
when i was flashing my w550i then in the middle of the flashing ,usb cable was disconnected and after that phone is like a dead !!!!what to do?????

and i was flashing my w550i for menu change...

try reflashing the firmwares...and cust packs

but this time use xs++ 2.2.

this ver of xs++ only works for w550i..