Help, my W810i will not turn on.

I need help. I have a W810i CID:46. When i put it to be charged or connect a usb cable to the phone it does not "wake up" and charge or connect to my pc. If I try turning the phone on normally i get nothing. I thought that the EROM was damaged and re-flashed it along with the Main and Fs. XS++ confirmed the sofware was flashed and performed successfully.

I again came to start the phone as normal and....Nothing not a beep, flashing red light or vibration... nothing, it's the same. (I had to use the service cable to flash it).

I've flashed a few K750 and W810i's now and this one's got me stumped.

Does anyone know anything i can try? I'm starting to think it's hardware.

Thanks in advance.

theres no W810 with CID46..only with CID 49

try to flash an older firmware..if nothing could help you have to send it to SE

take it to the service center coz it seems hardwear problem might the screen is gone so the better way to take to the proper DOCTOR ;)

Sorry my mistake - I mean CID:49.

The screen is fine i replaced it myself. When i first got the phone i turned it on and the broken screen (at the time) showed signes of life. I took several attepts before that happened.

I think it's been dropped and the solder surrounding the chips N2802, V246, B2200, D2230, X2600 and N2600 have been making intermittant contacts.

When i get the chance i'll check and let you know the results.

Thanks

u can falsh with older frimware

so the phone was damaged when you got it? It's better to take it to a sevice center, it might have other hardware problems.

Did you had it finalised???I had the same because I forget the finalising then I do it and it workes fine.