Printable View
Hi, I'm new to phone modding. My Z600 was just dead couple months ago.
I have no idea how to make it alive again.
Can anyone help me for this? I don't know what cable I should use for flashing Z600, I got no cables when I purchased the phone.
I've tried searching any solutions on the net, but I can't find one that help.
Sorry for my bad English, but anyways thanks for your help...
give some info about the phone... whi did it dye??? :D
unlucky on the possible death
good luck on fixing it
@ wisky_2004:
It's just dead. I can't turn it on. On the 1st time it happened, I still got the green lamp indicator on the phone's side blinking. I figured out that it was possible that the battery needed to be charged, so i fully charged it using desktop charger. And after that the phone still couldn't turns on, even the green light didn't blink anymore.
Any ideas??
You must use T28 service cable and program such like SEMC Tool in order to reflash firmware.
What the "T28 service cable" means?? It's a cable of SE T28 phone or special service calbe, or what?? What firmware/gdfs should I use then? 'Coz I didn't make any backups of my phone's software before. Thnx btw for your reply...
T28 service cable is for older phones with legacy system connector (T28,...,K600). It is slightly modified data cable. You must resolder some pins inside the standard data cable. Some guides for that are on davinciteam's site or just use search on the web. Link for firmware: http://seforum.dox.hu/z600/z600.htm
Ok, now I have T28 service cable I borrowed from my friend.
Thanks @ ivbuiliev for the link. But i still can't make my phone detected. I tried using SEMC 3.3, and I tried all available COM port too. Nothing happened!
I searched the web and many other forums, Maybe I should use testpoint or what??
Does anyone know how to make a testpoint in Z600??
Thanks for help....
You may try SEMC 2.2 also. About cable: first of all you need drivers for it, second is to check in Windows control panel the correct port. Finally after starting the program, connect the phone and press power button quickly several times. Your phone must be detected then. Don't use speed higher than 115200 also.