Printable View
hello guys..can anyone help me here
1) i got 2 phones se c510 n se w580i..wen i update my w580i through se update ,it goes on smoothly but when i try to update my c510 it doesnt works...when i press c it goes to mass storage mode...the same happens when i try to use it with a2 uploader...can anyone help...plz
2)Also a few days bak..my w580i got soaked in water....after tht i left the phone to dry n it worked normally xcept for the bluetooth...how can i revive my bluetooth back???
im no expert but i would say your w580i will slowly die unfortunately,in my experience any phones i have got wet in the past have started working again only to slowly over 6 months go wrong then die all together.
I have been told that if you get a phone wet there is a way of saving it but only applies if you do it straight away (within 24hrs),it's got something to do with stripping the phone down to the circuit board then soaking the board in a weak acid soloution to undo any damage the water has done to the board,wether this is true or not i dont know.
Have you tried holding down 2 and 5 instead of C then connecting your phone?
ya tried 2 n5 too....but my c510 goes 4 the mass storage mode
1)make sure that the driver is right then try holding down 2 and 5 instead of C
2)i wonder what did you do when your phone was in water. U should not hold cancel key to switch off the phone after that you can dry it by the hair-dryer(only cold air)