Printable View
Ok heres the story...
i think my erom or gdfs is broken D:
didnt back up gdfs
phone now blinks a few times uder infrared port
i flashed main and fs... i get nothing just blinking lights in infrared port
tried to read gdfs from setool2... it doesnt work... never finishes
i havent written any gdfs's to it yet...
but i dont have gdfs
can i mayb download one from here?
WHAT CAN I DO I DON'T HAVE GDFS!
help...
anybody there?
Try to flash your SE again....Let the battery charging for at least 2 or 3 hours and flash it!
make sure what CID is yours.
I have a at&t unlocked phone(Sony 580i)
yesterday I tried to update the software from SONY update service, But it faied to do, and now my phone is not even starting, plsss help
I tried to repair it with Se Tool2 but it is giving following message
welcome to setool2 lite edition v 1.07
supported DB2010/DB2012 CID49/50/51, DB2020 CID49/51/52
Loaded 51 flash descriptors
ChipID:9900,EMP protocol:0301
error while reading security units
SECURITY UNITS CAN'T BE READ !
DAMAGED FIRMWARE/GDFS OR EMPTY PHONE
phone pre-boot failed,possible RECOVERY needed.
Elapsed:7 secs.
sanfelice
i tried reflashing
stuck for 18 minutes then disconnected
I dont know ifit will work for your w850....but worked with my k800!
I used XS++ and as I connected the phone, the program updated the CID (it asks if u want to).
Make sure the battery has a good charge or try to use an universal charger (cos many problems appears due to low battery)! And even more important certifie what FS, MAIN an CDA you are using, and if they're compatible with the CID
Try to post what the Setool shows to you and write what FS, MAIN an CDA you're using
Hope it works
\,,/