my PC has turned off unexpectedly while flashing!!!

Now setool2 cracked stucks when I connect phone, other programs say unknown phone type, can I do something with it?

Maybe some problems with your USB Drivers.

every program stucks in this place
unknown ChipID (5A5A), RETRY
i've tried to reinstall drivers, but no result happened. Phone k500, service cable pl-2303 chip based. Cable 100% works, drivers are 100% tested... have anybody some ideas?

Quote:

---

Originally Posted by dicom

every program stucks in this place
unknown ChipID (5A5A), RETRY
i've tried to reinstall drivers, but no result happened. Phone k500, service cable pl-2303 chip based. Cable 100% works, drivers are 100% tested... have anybody some ideas?

---

Try connect your phone with PC using XS++ and DCU-60 (usb cable that came with phone) ,reinstall flash drivers and use this USB Flash Driver Installation - Guide - Top Sony Forums and this XS++ 2.x Guide - Top Sony Forums
but use XS++3.1 Darwin

DCU-60 comes with newer phones(fast port) - K500 uses DCU-11...
some more information about program's describtion:
"semc tool 8.4 free(cracked)":
Switch phone ON
Get phone info
Flash CID: 90 (must be 29)
Phone KEY: ZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZ ZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZZ
ERROR: 305011
"setool2 cracked" hangs and hangs my com port.
Sonics:
Lante Sonics is Ready..
Device ready.
Powering phone...
Warning: chip id read error.
Unknown phone, that's an error.
Time elapsed: 2 secs
"XS++ v3.2":
Attempting to open the interface...
Baseband ID: 5A5A
Protocol Version: 90.90
Speed set to 115200
Warning: IMEI name does not match GDFS name (IMEI:NULL GDFS:n/a)
...using GDFS name
Restarting phone - please wait...
Binary acknowledge failed with: 00
Failed
Failed
Baseband ID: 5A5A
Protocol Version: 90.90
Speed set to 115200
Phone has restarted successfully...
Profiling SEMC phone...
Platform: Unknown
OTP CID: 0
EROM CID: 1515870810
EROM Color: Unknown
IMEI: n/a
Phone ID: n/a
Region: n/a
CDA: n/a n/a
Firmware Version: n/a
EROM: n/a
Ready for operation!
Sorry, your phone is NOT SUPPORTED
Error: Cannot send flash loader
Error: Flashing failed
Disconnected... Unplug the phone
---- i'll remind that this happend when my pc turned off unexpectedly during the flash, everything was ok before... turned off because of bad drivers, as i did it very long ago i couldn't remember wich one of the drivers is ok :-(

i don't know how, but I've done it by myself - thanks everybody

I would think USb drivers problem if XS++ does not detect the phone! about JD geting stuck...odd...