Help me!!! k8@k81

My phone always freeze on me. Everytime that happens, I have to remove the battery then turn it back on. But it often stops at the SE logo. I tried to reflashed it many times, but no help...If I turn off the phone for a few minutes then turn it back on, it will be back to normal...Then it will freeze again after a short while. Then I have to start over again to get it fixed (turn off for a few mins then back on). Should there is any technical issue inside the phone? Would someone please tell me if this ever happen to your phone and/or how to fix this

Sorry for my english bad

Read here: REPAIRING EROM GUIDES for most sonyericsson phones - Top Sony Forums

Now when i connect to pc by SEtool:

Welcome to SEtool2 ( LITE edition ) v 1.11
supported DB2010/DB2012 CID49/50/51/52, DB2020 CID49/51/52
Loaded 51 flash descriptors

if you like LITE edition - please visit Index of ./ and buy FULL.

ChipID:9900,EMP protocol:0301

OBSOLETE EROM,FORCING COLOR -> RED
OBSOLETE EROM,FORCING CID -> 49

erom_readvar: error reading unit 0/6
error while reading security units
SECURITY UNITS CAN'T BE READ !
DAMAGED FIRMWARE/GDFS OR EMPTY PHONE
phone pre-boot failed,possible RECOVERY needed.
Elapsed:5 secs.

Sorry my English bad
hixhix.....Helpme

your phone is dead try to recover your backed up GDFS and if you dont get backup you are is trouble

yep if don't have gdfs backup you ld take it to a service center

I recommend that you do the following:
1)Do a full flash (MAIN,FS,Customization)
2)Repair your GDFS,there is a guide about it at "Tutorials" section
3)Repair your EROM with SeTool2Lite,NOT with wotan,davinci etc.

If the problem still persists (sth that personally I don't believe after you do these) it is certainly a hardware problem...

i have a w810i
i had usre Read GDFS to macke a backupwhit setolittle2 v1.11 and after backup the phone was dead nothing works dosent start up nothing
(the batery was full)
??????

Ddi you try put back GDFS ?

sorry he backup dosent finish i had stay 6 minutes afther thath i have click on she stop buton:)

ok man the problem was the contact pins of the phone :P
i hade conect the batery charger then i conect the dcu cable to the charger