Hello there
I upgraded the software on my W880i, the client sad it was all done successfully, and then I turned on the phone, and the phone says please wait, and it starts to reseting and all the time saying please wait & the bar stuck at 75%,so all the time when I try to power it up it says: Please Wait" start-up screen, and that's all it will do, if I connect it via cable to the computer, the client still recognize it and win xp too, but for a moment, then the phone kinda resets and that's repeating all the time. I also tried with davinci and d-client and the flashing was always successful, but the problem is the same, when I turn on the phone, it says please wait and the bar stuck at 75% and the phone starts to reset..
So where is the problem can anyone help me pls..?
Some info:
welcome to setool2 lite edition v 1.08
supported DB2010/DB2012 CID49/50/51/52, DB2020 CID49/51/52
Loaded 51 flash descriptors
ChipID:9900,EMP protocol:0301
PHONE IS RED RETAIL PRODUCT
FLASH CID detected:52
Speed:921600
Flash ID check:897E
Flash props sent ok
OTP LOCKED:1 CID:51 PAF:1 IMEI:354649013***** CERT:RED
FLASH CID:52 COLOR:RED
MAPP CXC article: R6CA001 prgCXC1250642_ORANGE_AI
MAPP CXC version: R6CA001
Language Package:ORANGE_GEN
CDA article: CDA102719/78
CDA version: R3A
Default article: cxc1250651
Default version: R6CA001
Network LOCKED
Operator: 234-33
Elapsed:17 secs.