Guess that we have a phone in this status:
We are talking about a "Emptyboard" phone....v0.914037/UNI
CARD SERIAL: 000XXXXX
Loaded 51 flash descriptors
SIGNED MODE (USING SERVER).
Open COM port OK
Can't load ID loader !
PROCEDURE WAS STOPPED BY USER
Elapsed: 37 secs.
ChipID000,EMP protocol:0301
erom_readvar: error reading unit 1/851
error while reading SIMLOCK SIGNATURE unit
phone was tampered with other software
SECURITY UNITS CAN'T BE READ !
DAMAGED FIRMWARE,GDFS OR EMPTY PHONE
OTP LOCKED:0 CID:0 PAF:0 IMEI:EMPTYBOARD CERT:N/A
IMEI MISMATCH ! GDFS IMEI:00000000000000
erom_readvar: error reading unit 2/DBB
erom_readvar: error reading unit 2/DE5
erom_readvar: error reading unit 2/E15
erom_readvar: error reading unit 2/E16
erom_readvar: error reading unit 2/DE7
erom_readvar: error reading unit 2/DE8
erom_readvar: error reading unit 2/DE9
erom_readvar: error reading unit 2/DEA
erom_readvar: error reading unit 2/DEB
PROVIDER: 000-00
SIMLOCKS NOT DETECTED
RESTORATION FILE NOT PRESENT
"00000000000000"
YOU MUST PERFORM FULL FLASHING
WHEN "ALTERNATIVE SECURITY BYPASS" ENABLED
BYPASS PACKAGE NOT PRESENT
"00000000000000.zip"
YOU MUST FLASH SUPPORTED FIRMWARE
TO USE "ALTERNATIVE SECURITY BYPASS"
var not exists
var not exists
var not exists
var not exists
SECURITY UNITS BACKUP CREATED.
Whether because we change the flash chip with a new one or because the phones are prototypes
-In Setool2 we'll work this phones in the "Emptyfill & Repair" Tab
SETOOL 3 BOX SUPPORTS EMPTYFILL OF DB2010/12 & DB2020
At the time is not supported PNX5230, less DB3150 (As we shall of course)
Steps to follow?
DB2020
Go to the tab "Emptyfill & Repair"
- Select Model ...
- Select CID49 (for all)
-Press Recovery....
-Add in files a GDFS in ssw format (depending on the model) and the EROM "DB2020EROM_CNV_RED52_BROWN_CID49_DB2020.ssw" that works for al the DB2020 (you can find them in the setool's folder)
-Fill the IMEI number and check "Write IMEI to OTP"
-Press FLASH
When this process ends do fullflash the firmware version desired and the phone will work as a normal one....
FOR DB2000, DB2010/12
-Select model
-Select CID:
29/36 for old models
49 for DB2010
51 for DB2012
-Press recovery
-Then add in files the GDFS in ssw format and the EROM (for the model) (For DB2012 use "db2012_erom_cid51.ssw")
(they can be found in the folder setool)
- Fill the field of IMEI and mark the box "Write OTP"
-Press FLASH
When this process ends do fullflash the firmware version desired and the phone still works as a normal
That's all
Ivan08v
Regards